Alternative Approach for the Intercritical Annealing of (Cr, Mo, V)-Alloyed TRIP-Assisted Steel before Austempering

TRIP-assisted C-Si-Mn steels are usually subjected to austempering with a preliminary intercritical annealing that is targeted at the multi-phase structure with 40-60 vol.% of proeutectoid ferrite. The kinetics and the mechanism of phase-structural transformations can be impacted due to the additional alloying of TRIP-assisted steel by the strong carbide forming elements, thus necessitating an alternative approach for the selection of intercritical annealing parameters. This issue is analyzed in the present work, which investigates the effect of the temperature of intercritical annealing on the "Structure/Properties" correlations in 0.2 wt.% C-Si-Mn-Nb steel additionally alloyed by 0.55 wt.% Cr, 0.20% Mo, and 0.11 wt.% V. The annealing temperature ranged from 770 degrees C to 950 degrees C, and austempering was performed at 350 degrees C for 20 min. It was observed that the addition of the (Cr, Mo, and V) complex significantly improved the steel hardenability. However, the annealing of steel at 770 degrees C (to gain 50 vol.% of proeutectoid ferrite) resulted in the precipitation of coarse cementite lamellas during bainite transformation, thus lowering the amount of retained austenite (RA) and decreasing the strength and ductility of the steel. At higher annealing temperatures, carbide-free bainite was formed, which presented a 2.5-3.5 times increase in the RA volume fraction and a 1.5 times increase in the RA carbon content. The optimal combination of the mechanical properties (UTS of 1040 MPa, TEL of 23%, V-notch impact toughness of 95 J/cm(2), PSE of 23.9 GPa center dot%) referred to annealing at a temperature close to the Ac-3 point, resulting in a structure with 5 vol.% ferrite and 9 vol.% RA (the residue was carbide-free bainite). This structure presented an extended manifestation of the TRIP effect with an enhanced strain hardening rate due to strain-induced martensite transformation. The impact of the alloying elements on the carbon activity in austenite served as the basis for the analysis of structure formation.