Simplified model reference-based autotuning for digitally controlled SMPS

This paper presents a closed-loop self-tuning technique for digitally controlled dc–dc switched-mode power supplies (SMPS) based on proportional-integral-derivative (PID) regulators, which derives from the more general model reference autotuning techniques. After briefly discussing an open loop, model-reference based tuning technique, a closed-loop solution is presented in which a perturbation frequency generated digitally is injected into the control loop and superimposed to the duty cycle command. The tuning is performed elaborating the signals right before and right after the injection point, and adjusting the PID parameters until predefined bandwidth and phase margin targets are obtained.Theproposed approach allowsfor a robustandrepeatable tuning, mainly because of the high resolution and dynamics available at the signal injection point. Moreover, the tuning is performed maintaining the closed-loop configuration, thus ensuring voltage regulation even during the PID adjustment, this being a fundamental constraint for most electronic equipments. The proposed technique is simple from the signal processing point of view, since it requires a few integrations, multiplications and phase-shift; further simplified implementations by employing nonsinusoidal perturbation waveforms like square-wave or triangular signals are also proposed. The approach is first discussed for two-parameters PI and PD regulators, and successively extended to PID structures, for whichtwopossible implementations areproposed.Theeffectiveness of the tuning approach is verified by means of computer simulations and experimental tests carried out on a digital signal processor platform interfaced with a prototype point-of-load converter. The complexity of an HDL-implementation of the tuning hardware for field programmable gate array platforms is also discussed.