3D-printed zeolite 13X-Strontium chloride units as ammonia carriers

The selective catalytic reduction (SCR) system in automobile using urea solution as a source of NH3 suffer from solid deposit problem in pipe lines and poor efficiency during engine startup. Although direct use of high pressure NH3 is restricted due to safety concern, which can be overcome by using solid sorbents as NH3 carrier. Strontium chloride (SrCl2) is considered the best sorbent due to its high sorption capacity; however, challenges are associated with the processing of stable engineering structures due to extraordinary volume expansion during the NH3 sorption. This study reports the fabrication of a novel structure consisting of a zeolite cage enclosing the SrCl2 pellet (SPZC) through extrusion-based 3D printing (Direct Ink Writing). The printed SPZC structure demonstrated steady sorption of NH3 for 10 consecutive cycles without significant uptake capacity and structural integrity loss. Furthermore, the structure exhibited improved sorption and desorption kinetics than pure SrCl2. The synergistic effect of zeolite as physisorbent and SrCl2 as chemisorbent in the novel composite structure enabled the low-pressure (<0.4 bar) and high-pressure (>0.4 bar) NH3 sorption, compared to pure SrCl2, which absorbed NH3 at pressures above 0.4 bar. Regeneration of SPZC composite sorbent under evacuation showed that 87.5% percent of NH3 was desorbed at 20 °C. Thus, the results demonstrate that the rationally designed novel SPZC structure offers safe and efficient storage of NH3 in the SCR system and other applications.